« previous next »
Pages: [1]   Go Down

Author Topic: [Solved] OXCE+ 'Invalid surface set' error: not enough frames?  (Read 2853 times)

Offline Keth01

  • Captain
  • ***
  • Posts: 50
    • View Profile
[Solved] OXCE+ 'Invalid surface set' error: not enough frames?
« on: May 02, 2018, 02:51:25 am »
Hi all,

I'm getting this error on a BigObject that I swear was working previously and I haven't touched it. It's a direct lift from Reaver's Mod (barring conversion to .png) too. I converted it using the same process as all my other resources and the problem is isolated to the attached file.

I'd be grateful for any advice you can offer.
« Last Edit: February 11, 2023, 05:11:39 pm by Meridian »
Logged

Offline ohartenstein23

  • Commander
  • *****
  • Posts: 1933
  • Flamethrowers fry cyberdisk circuits
    • View Profile
Re: OXCE+ 'Invalid surface set' error: not enough frames?
« Reply #1 on: May 02, 2018, 05:38:46 am »
It's probably not the image itself, but a typo in the ruleset somewhere. Can you post a copy of the ruleset/mod?
Logged

Offline Keth01

  • Captain
  • ***
  • Posts: 50
    • View Profile
Re: OXCE+ 'Invalid surface set' error: not enough frames?
« Reply #2 on: May 02, 2018, 03:09:52 pm »
Bingo! Bad reference number in the item definition. Thanks for pointing out where to look :)
Logged
Pages: [1]   Go Up
« previous next »