OpenXcom Forum

OpenXcom Forks => OpenXcom Extended (OXCE) => OXCE Support => Topic started by: Keth01 on May 02, 2018, 02:51:25 am

Title: [Solved] OXCE+ 'Invalid surface set' error: not enough frames?
Post by: Keth01 on May 02, 2018, 02:51:25 am

Hi all,

I'm getting this error on a BigObject that I swear was working previously and I haven't touched it. It's a direct lift from Reaver's Mod (barring conversion to .png) too. I converted it using the same process as all my other resources and the problem is isolated to the attached file.

I'd be grateful for any advice you can offer.

Title: Re: OXCE+ 'Invalid surface set' error: not enough frames?
Post by: ohartenstein23 on May 02, 2018, 05:38:46 am

It's probably not the image itself, but a typo in the ruleset somewhere. Can you post a copy of the ruleset/mod?

Title: Re: OXCE+ 'Invalid surface set' error: not enough frames?
Post by: Keth01 on May 02, 2018, 03:09:52 pm

Bingo! Bad reference number in the item definition. Thanks for pointing out where to look :)